Open the box that contains new huge epson artisan 710 printer.
Remove all the covers and tapes from the printer.
Make sure that you remove all the tapes from the scanner glass, input tray and the ink cartridge holders. If any packing materials is left in the printer, it may damage your print You will find your epson artisan 710 printer, photo paper to use, CD printing tray with which you will be able to print directly onto a CD, power cord, software installation CD, free Adobe Photoshop elements and six Claria Hi-Definition high capacity ink cartridges inside the package.
Connect the power cord to your new epson artisan 710 setup printer and to an electrical outlet.
Power on your epson artisan 710 printer using the power button in front of your printer.
Wait for sometime until the printer gets started.
Take away the ink cartridges from its packing.
Remove the yellow coloured tape from the ink cartridge.
Place the ink cartridge in the holder facing the coloured tape side up.
Install all the ink cartridges in the specified cartridge holder in the printer.
After installing all the ink cartridges, allow your epson artisan 710 printer to install ink.
If your ink didn’t get installed, then remove the cartridges and reinstall them properly in the holders.
At once installation of ink is completed, you will get a prompt message in the printer’s control panel.
Load papers in the input tray which could accommodate up to 100 sheets .
Your all new epson artisan 710 printer is ready to use.
Whatever problem occurs in your Epson artisan 710 printer, first unplug your printer. While you unplug your printer, your printer must be turned on. Then, remove the power cord from the electrical outlet. Leave your printer for sometime and then power on your Epson 710 printer.
Power on your epson 710 printer. Just press the ink cartridges and remove it from the holder. Reinstall them properly in the holders again. Repeat it for several times. If you are using the refilled ink cartridges, then make sure that the ink cartridges are cleaned nicely. Clean the electrical contacts in the ink cartridges. And reinstall them after some time.
If the edge guides are tightened too much, it may be one of the reasons for the paper stuck issues. If the papers are stuck, then remove the ink cartridges from the holders and check whether any paper is stuck inside the holders. Remove them and reinstall the cartridges again. Also, check whether any paper is stuck in the rollers. And remove them. Remove the papers in the input tray and place them properly in the tray and adjust the edge guides to the correct size.
Turn on your printer. Clean the printer rollers with the distilled water and wet pads. Rinse the pad in the distilled water and remove excess water by using a clean cotton. Then, use it to clean the print head nozzles and rollers. If it does not clear your problem, then go for servicing.